How to Avoid Electrical Accidents in Construction Sites

Some workplaces are more dangerous than others. A good example of this is construction sites, where workers, and even passersby, are exposed to numerous hazards, such as defective equipment, falling debris, and exposed wires.

According to the website of Brunkenhoefer P.C., electrical accidents are some of the most common accidents in construction sites. This is understandable, because construction sites are mostly unfinished products, so they may still have defective electrical systems, exposed wires, and opened power lines.

But this does not mean that employers should just accept this fact without doing anything. They should make the effort of making their construction sites safe not just from electrical accidents, but accidents in general.

Giving protective gear

Workers may inherently deal with electricity, so simply avoiding electrical hazards wouldn’t work as a safety measure. The least an employer can do is to issue the proper protective gears, such as rubber gloves, non-conductive hard hats, sleeves, and other equipment that will minimize or completely neutralize conduction.

Having proper insulation

Workers may accidentally make contact with exposed cables and wires, resulting into electrocution. To prevent such things from happening, the wirings should be coated with insulating materials, such as glass, plastic, and rubber, as these will contain the electrical conduction.

Grounding electric equipment

Construction sites are legally required to have an adequate grounding program, either by using Ground Fault Circuit Interrupters (GFCIs) or enforcing grounding procedures from a competent person. Despite the requirement, proper grounding of electrical equipment is one of the most commonly violated safety standards in construction sites.

Avoiding overloads

Sometimes, electrical accidents are not caused by incompetence, but by mere negligence. Plugging in too many electrical devices in a single circuit may cause overloading, ultimately leading to fires, breakage of electrical devices, melting of insulation coats around the wires, and electric shock.

Using barriers and signs

Basic safety measures such as the installation of barriers around areas that are exposed to energized equipment and of warning signs near electrical conductors should not be overlooked. Workers may be too mentally fatigued or negligent to avoid simple electrical accidents, so they may need reminders like barriers and signs.

Leave a Reply

Your email address will not be published. Required fields are marked *